This is an old revision of the document!
|1||PCB Power Switch 1|
|2||Diode 1N4148||D1, D2|
|2||Resistor 560R green-blue-brown||R1, R2|
|1||Resistor 1M brown-black-green||R3|
|1||Voltage regulator LP2950Z||IC3|
|1||Connector AVR ISP 6pin angled||JP1|
|1||Connector Switched Output 3pin||X1|
|1||Connector 1 pin header (for serial TX debugging)||JP5|
|1||Relay FTR-K1C (230V, 16A)||K1|
|1||Transceiver PCB RFM12B||IC2|
|1||Antenna (82,2mm wire)|
maybe extra pins, at your opinion.
As always: start from flat to high. Go through the partlist and solder the parts from the top ones to the last ones.
For some parts, you have to consider something special:
(Image directly loaded from external GitHub source. If it doesn't work, fix link in wiki!)
After flashing and switching the power on, your power switch should blink three times slowly. If you haven't flashed working EEPROM settings, it flashed quickly endlessly.
In normal operation, the LED shows the status of the relay. If a timeout is counting down, it flashed very shortly once a second to indicate this.