rfm12b_soldering
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
rfm12b_soldering [2014/05/31 19:02] – breaker27 | rfm12b_soldering [2014/05/31 19:03] – [Prepare the solder pins] breaker27 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Prepare the solder pins ====== | ====== Prepare the solder pins ====== | ||
- | Apply a tiny bit of solder to the pins of the RFM12B transceiver before you solder it to the PCB of the smarthomatic device. You don't need to do this with every pin, but only with the ones that will be connected later on. See the picture below. | + | Apply a tiny bit of solder to the pins of the RFM12B transceiver before you solder it to the PCB of the smarthomatic device |
====== Applying Paperboard / Isolation ====== | ====== Applying Paperboard / Isolation ====== |
rfm12b_soldering.txt · Last modified: 2015/02/21 21:21 by breaker27