User Tools

Site Tools


led_soldering

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
led_soldering [2015/02/21 21:31]
breaker27
led_soldering [2015/02/21 21:31] (current)
breaker27
Line 10: Line 10:
   - Put a little solder to the tip of your soldering iron.   - Put a little solder to the tip of your soldering iron.
   - Place one tinned end of one cable next to one pin of the LED and hold the soldering iron's tip to them for about half a second. This should create a nice solder joint.   - Place one tinned end of one cable next to one pin of the LED and hold the soldering iron's tip to them for about half a second. This should create a nice solder joint.
-  - Do the same for the 2nd cable.+  - Do the same for the 2nd cable and the other pin of the LED.
   - Get about 10mm of heat shrink tube and place it over the soldering area.   - Get about 10mm of heat shrink tube and place it over the soldering area.
   - Heat the tube shortly and carefully with the flame of a pocket lighter. It shrinks and should isolate the soldering area afterwards.   - Heat the tube shortly and carefully with the flame of a pocket lighter. It shrinks and should isolate the soldering area afterwards.
led_soldering.txt ยท Last modified: 2015/02/21 21:31 by breaker27