smarthomatic

User Tools

Site Tools

Trace:
temp_sensor

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
temp_sensor [2014/03/02 17:58] – [Integrate it into a housing] breaker27temp_sensor [2014/04/15 21:22] – [Building up a Temeprature and Humidity Sensor] breaker27
Line 1: Line 1:
-====== Building up a Temeprature and Humidity Sensor ======+====== Building up an Environment Sensor ======
  
 ===== Needed Parts and PCB ===== ===== Needed Parts and PCB =====
Line 60: Line 60:
  
 {{:sht15_connection.jpg?nolink |}} Connect the SHT15 sensor to a ribbon cable by soldering the four pins shown on the picture. {{:sht15_connection.jpg?nolink |}} Connect the SHT15 sensor to a ribbon cable by soldering the four pins shown on the picture.
 +
 +After that, solder the other end of the wires to the PCB. The picture is from the top side of the PCB. The border of the PCB is at the bottom of the picture.