temp_sensor
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
temp_sensor [2014/03/02 17:11] – [Needed Parts and PCB] breaker27 | temp_sensor [2014/04/15 21:22] – [Building up a Temeprature and Humidity Sensor] breaker27 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Building up a Temeprature and Humidity | + | ====== Building up an Environment |
===== Needed Parts and PCB ===== | ===== Needed Parts and PCB ===== | ||
Line 56: | Line 56: | ||
After flashing and switching the power on, your temp sensor should blink quickly for some seconds. After that, it only flashes shortly once whenever a temperature data packet is sent (>5 min). | After flashing and switching the power on, your temp sensor should blink quickly for some seconds. After that, it only flashes shortly once whenever a temperature data packet is sent (>5 min). | ||
+ | |||
+ | ===== Connect the SHT15 ===== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | After that, solder the other end of the wires to the PCB. The picture is from the top side of the PCB. The border of the PCB is at the bottom of the picture. | ||
+ | |||
===== Integrate it into a housing ===== | ===== Integrate it into a housing ===== | ||
describe it... | describe it... |