Differences

This shows you the differences between two versions of the page.

--- soil_moisture_meter [2015/01/06 17:36] – [Partlist (in buildup order)] breaker27
+++ soil_moisture_meter [2015/01/29 22:43] – [Partlist (in buildup order)] breaker27
@@ Line 14: / Line 14: @@
 |    1     | Transceiver PCB RFM12B                  | IC2        |  {{ parts:ic_rfm12b.jpg }}                   |
 |    1     | IC 74HC14D                              | IC3        |  {{ parts:ic_smd_74hc14d.jpg }}              |
-|    1     | Connector AVR Mini ISP 6pin             | JP1        |  {{ parts:connector_isp.jpg }}               |
+|    1     | Connector AVR Mini ISP 6pin             | JP1        |  {{ parts:connector_mini_isp.jpg }}               |
 |    1     | Connector pin header (for serial TX debugging etc.)  | JP3   |  {{ parts:connector_pinheader.jpg }}  |
 |    1     | Antenna (82,2mm wire)                   | ANT        |  {{ parts:antenna.jpg }}                     |
@@ Line 21: / Line 21: @@
 |    1     | Resistor 1M                             | R2         |  {{ parts:resistor_smd_603.jpg }}            |
 |    1     | Resistor 100k                           | R3         |  {{ parts:resistor_smd_603.jpg }}            |
-|    1     | Switch                                  | S1         |  {{ parts:switch.jpg }}                      |
+|    1     | Switch                                  | S1         |  {{ parts:button.jpg }}                      |
 ===== Buildup of PCB =====
@@ Line 33: / Line 32: @@
   - Now connect a multimeter to **check the power consumption**. Press the button when the device starts up. The device will blink some seconds very fast and then go to power down mode. **The device should draw only ~0.1µA.** If the current is much higher, you may have a short circuit somewhere.
   - Solder the debug TX pin, the RFM12B module and antenna with a soldering iron as usual.
+  - Switch on the device and check power consumption again. With connected RFM12, it should now be ~1.7µA.
 {{https://raw.github.com/breaker27/smarthomatic/develop/hardware/soil_moisture_meter/placing.png?500}}