setup_avrdude
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
setup_avrdude [2013/10/03 15:57] – created breaker27 | setup_avrdude [2014/03/15 14:16] (current) – [Check the programmer connection] breaker27 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
- | After installing avrdude, create a file **avrdude.rc** in the same directory as your avrdude.exe | + | You should create a config file for avrdude containing your default settings. After the config file is created, you can use avrdude without entering the settings each time. This also makes it possible to leave this parameters out of the makefiles. |
+ | |||
+ | ===== Create config file under Windows ===== | ||
+ | |||
+ | After installing avrdude, create a file **avrdude.rc** in the same directory as your avrdude.exe with the following content: | ||
< | < | ||
Line 8: | Line 12: | ||
</ | </ | ||
- | (change your settings as needed). After this is set up, you can use avrdude | + | (change your settings as needed). |
+ | |||
+ | ===== Create config file under Linux ===== | ||
+ | |||
+ | After installing | ||
+ | |||
+ | < | ||
+ | default_serial = "/ | ||
+ | default_programmer = " | ||
+ | </ | ||
+ | |||
+ | (change your settings as needed). | ||
====== Check the programmer connection ====== | ====== Check the programmer connection ====== | ||
- | Connect | + | Now connect |
Try to read out the fuses: | Try to read out the fuses: | ||
Line 31: | Line 46: | ||
If not, check all connections or if you have a shortcut. | If not, check all connections or if you have a shortcut. | ||
- | You can use " | + | You can use " |
setup_avrdude.1380808665.txt.gz · Last modified: 2013/10/04 18:56 (external edit)