setup_avrdude
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
setup_avrdude [2013/10/03 15:57] – created breaker27 | setup_avrdude [2014/03/15 14:12] – breaker27 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Setup avrdude ===== | + | ====== Setup avrdude |
- | After installing avrdude, create a file **avrdude.rc** in the same directory as your avrdude.exe | + | After installing avrdude, create a file **avrdude.rc** in the same directory as your avrdude.exe with the following content: |
< | < | ||
Line 8: | Line 8: | ||
</ | </ | ||
- | (change your settings as needed). After this is set up, you can use avrdude without entering these settings each time. This also makes it possible to leave this parameters out of the makefiles. | + | (change your settings as needed). |
- | ====== | + | ====== |
- | Connect | + | After installing avrdude, create a file **.avrduderc** in your home directory with the following content: |
+ | |||
+ | < | ||
+ | default_serial = "/ | ||
+ | default_programmer = " | ||
+ | </ | ||
+ | |||
+ | (change your settings as needed). | ||
+ | |||
+ | ===== Check the programmer connection ===== | ||
+ | |||
+ | After the config file is created as shown above, you can use avrdude without entering the settings each time. This also makes it possible to leave this parameters out of the makefiles. | ||
+ | |||
+ | Now connect | ||
Try to read out the fuses: | Try to read out the fuses: | ||
Line 32: | Line 45: | ||
You can use " | You can use " | ||
- |
setup_avrdude.txt · Last modified: 2014/03/15 14:16 by breaker27