rgb_dimmer
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
rgb_dimmer [2015/02/22 20:15] – [Recommended LED module and resistors] breaker27 | rgb_dimmer [2023/02/28 13:49] – breaker27 | ||
---|---|---|---|
Line 76: | Line 76: | ||
- | For the " | + | With the " |
Use resistors which can tolerate the power they consume. The power is calculated as: | Use resistors which can tolerate the power they consume. The power is calculated as: | ||
Line 83: | Line 83: | ||
with U_Res the voltage at the resistor. | with U_Res the voltage at the resistor. | ||
+ | |||
+ | ===== Modification of PCB rev. <= 1.1 ===== | ||
+ | |||
+ | The older PCBs have the speaker connected to PD3 (pin5). Since the 16 bit timer has to be used to generate accurate frequencies, | ||
+ | |||
+ | The pin to drive the transistor for the blue LED has to be moved from PB1 (pin 15) to PD3 (pin 5). | ||
+ | |||
+ | In future PCB versions, this shall be changed in the schematic and layout. | ||
+ | |||
+ | To perform the modification, | ||
rgb_dimmer.txt · Last modified: 2023/02/28 14:24 by breaker27