Differences

This shows you the differences between two versions of the page.

--- openhab-examples [2015/06/28 19:46] – [A flood detection sensor] GoHoHa
+++ openhab-examples [2015/06/29 00:17] (current) – breaker27
@@ Line 1: / Line 1: @@
-====== Exapmles for OpenHAB ======
+====== Examples for OpenHAB ======
 At this page we collect example configurations for the OpenHAB integration of smarthomatic devices.
@@ Line 7: / Line 7: @@
 ====== Item definitions ======
+An EnvSensor with Temperature + Humidity message:
+<code>Number Temp1 "Temperature1 [%.1f °C]" <temperature> (gTemperature) {smarthomatic="<[deviceId=123, messageGroupId=10, messageId=2, messagePart=1:JS(getDiv100.js)]"}
+Number Humi1 "Humidity1 [%.0f]" (gHumidity) {smarthomatic="<[deviceId=2, messageGroupId=10, messageId=2, messagePart=0:JS(getDiv10.js)]"}</code>
+A battery status message:
+<code>Number Batt1 "Battery1 [%.0f]" (gBattery) {smarthomatic="<[deviceId=123, messageGroupId=0, messageId=5]"}</code>
+Two switches connected to a GPIO pins and mapped to DigitalInputPin 0 and 1 in e2p  :
+<code>Switch Switch1 "Switch1" (gSwitch) {smarthomatic="<[deviceId=123, messageGroupId=1, messageId=1, messagePart=0]"}
+Switch Switch1 "Switch1" (gSwitch) {smarthomatic="<[deviceId=123, messageGroupId=1, messageId=1, messagePart=1]"}</code>
@@ Line 13: / Line 23: @@
 Based on the EnvSensor the short between a GPIO-PIN and GND or a special switch can be used as a water detection sensor.
-The item definition on OpenHAB (the contacts are mapped in e2p to the third port):
+The item definition on OpenHAB (the contacts are mapped to the third DigitalInputPin in e2p):
-<code>Switch	Water_Basement	"Water sensor basement [MAP(water.map):%s]"	(gBasement,gSensorWater,gSensor) {smarthomatic="<[deviceId=123, messageGroupId=1, messageId=1, messagePart=2]"}</code>
+<code>Switch Water_Basement "Water sensor basement [MAP(water.map):%s]"	(gBasement,gSensorWater,gSensor) {smarthomatic="<[deviceId=123, messageGroupId=1, messageId=1, messagePart=2]"}</code>
 The water.map file: