led_soldering
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
led_soldering [2015/02/21 21:31] – breaker27 | led_soldering [2015/02/21 21:31] (current) – breaker27 | ||
---|---|---|---|
Line 10: | Line 10: | ||
- Put a little solder to the tip of your soldering iron. | - Put a little solder to the tip of your soldering iron. | ||
- Place one tinned end of one cable next to one pin of the LED and hold the soldering iron's tip to them for about half a second. This should create a nice solder joint. | - Place one tinned end of one cable next to one pin of the LED and hold the soldering iron's tip to them for about half a second. This should create a nice solder joint. | ||
- | - Do the same for the 2nd cable. | + | - Do the same for the 2nd cable and the other pin of the LED. |
- Get about 10mm of heat shrink tube and place it over the soldering area. | - Get about 10mm of heat shrink tube and place it over the soldering area. | ||
- Heat the tube shortly and carefully with the flame of a pocket lighter. It shrinks and should isolate the soldering area afterwards. | - Heat the tube shortly and carefully with the flame of a pocket lighter. It shrinks and should isolate the soldering area afterwards. |
led_soldering.txt · Last modified: 2015/02/21 21:31 by breaker27