led_soldering
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
led_soldering [2015/02/21 21:28] – breaker27 | led_soldering [2015/02/21 21:31] – breaker27 | ||
---|---|---|---|
Line 9: | Line 9: | ||
- Cut the tinned ends of the cables down to about 2mm. | - Cut the tinned ends of the cables down to about 2mm. | ||
- Put a little solder to the tip of your soldering iron. | - Put a little solder to the tip of your soldering iron. | ||
- | - Place a tinned end of one cables | + | - Place one tinned end of one cable next to one pin of the LED and hold the soldering iron's tip to them for about half a second. This should create a nice solder joint. |
- Do the same for the 2nd cable. | - Do the same for the 2nd cable. | ||
- Get about 10mm of heat shrink tube and place it over the soldering area. | - Get about 10mm of heat shrink tube and place it over the soldering area. |
led_soldering.txt · Last modified: 2015/02/21 21:31 by breaker27