led_soldering
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| led_soldering [2015/02/21 21:28] – breaker27 | led_soldering [2015/02/21 21:28] – breaker27 | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| - Cut the wires on the LED down to about 4mm. | - Cut the wires on the LED down to about 4mm. | ||
| - Put a little solder to the wires of the LED. | - Put a little solder to the wires of the LED. | ||
| - | - Cut two cables of about 5cm and remove the insulation for about 5mm at the ends. | + | - Cut two cables of about 5-10cm |
| - Put a little solder to the ends of the cables. | - Put a little solder to the ends of the cables. | ||
| - Cut the tinned ends of the cables down to about 2mm. | - Cut the tinned ends of the cables down to about 2mm. | ||
led_soldering.txt · Last modified: 2015/02/21 21:31 by breaker27