flash_the_atmega
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
flash_the_atmega [2013/10/20 10:58] – [Three different storage areas] breaker27 | flash_the_atmega [2023/03/01 19:40] (current) – [Using flash scripts] breaker27 | ||
---|---|---|---|
Line 34: | Line 34: | ||
(replace ?? by the hex value for the needed fuse settings and use " | (replace ?? by the hex value for the needed fuse settings and use " | ||
+ | |||
+ | ===== Strange avrdude error messages ===== | ||
+ | |||
+ | Some fuses only use a part of their bits. If you set such a fuse, avrdude may complain at verification that it read out another value than it wrote. | ||
+ | |||
+ | Writing the EFuse of the ATMega168 or 328 returns a value of only the last 3 bits (upper 5 unused), so a value of xxxxxyyy is read out as 00000yyy. Example: | ||
+ | |||
+ | < | ||
+ | avrdude: verification error, first mismatch at byte 0x0000 | ||
+ | 0xfc != 0x04 | ||
+ | avrdude: verification error; content mismatch | ||
+ | </ | ||
+ | |||
+ | Don't worry. The warning is only returned because avrdude does not know that the upper 5 bits are always 1 (as per spec). | ||
====== Flashing the firmware / eeprom ====== | ====== Flashing the firmware / eeprom ====== | ||
Line 43: | Line 57: | ||
* **flash.cmd** / **flash.sh** for flashing firmware, eeprom and fuses | * **flash.cmd** / **flash.sh** for flashing firmware, eeprom and fuses | ||
* **flash_firmware.cmd** / **flash_firmware.sh** for flashing only the firmware | * **flash_firmware.cmd** / **flash_firmware.sh** for flashing only the firmware | ||
- | * FIXME: The Linux scripts do not exist yet. | ||
===== Using a make rule ===== | ===== Using a make rule ===== |
flash_the_atmega.1382259521.txt.gz · Last modified: 2013/10/20 10:58 by breaker27