base_station
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
base_station [2013/10/21 17:18] – [Buildup of PCB] Inhumierer | base_station [2013/11/11 19:32] – [Integrate it into a housing] add text and pictures GoHoHa | ||
---|---|---|---|
Line 58: | Line 58: | ||
===== Integrate it into a housing ===== | ===== Integrate it into a housing ===== | ||
- | describe | + | This is an example how to integrate the electronics into a nice housing. |
+ | Here a black plastic housing was used ([[http:// | ||
+ | The left figure shows the planned arrangement of parts: The smarthomatic base-station pcb, the FTDI FT232RL based serial USB adapter and the LEDs. | ||
+ | The housing contains 4 pins inside for screw mounting, but it was on the wrong place, so it was removed with a drill and a chisel. On the side wall the marks for the USB-port and the LEDs are visible. | ||
+ | The third figure shows the final assembly, the second LED was omitted. | ||
+ | All parts were fixed with hot glue. | ||
+ | |||
+ | ^{{: | ||
+ | |::: |
base_station.txt · Last modified: 2014/03/02 17:11 by breaker27