====== Movement detection by PIR sensor HC-SR501======

===== General =====

There are fairly cheap PIR sensors available under the name **HC-SR501**.
According to various pages this sensors are really nice. Here some features:

  * less than 80uA power consumtion (max 150 uA while motion is detected)
  * adjustable sensitivity and range 3 to 7m
  * prepared to attach a photoresitor
  * output signal is 3.3 V high / low signal
  * VCC range is 4.5 to 20V

Measured at a sample it uses 35 µA if idle. If movement is detected the OUT pin goes from 0.0 V to 3.3 V and uses than 190 µA.

===== Wiring =====

The PCB has a voltage regulator, a HT7133-1, which is used to make a stable 3.3 V from the VCC (4.5 V to 20 V). So we drive the combination of Env-Senso Board and HC-SR501 by 4 AA batteries and solder additional pins to the PCB as power source for the EnvSensor.

{{ :pir2env.png?direct&500 |}}

//Add changes to monitor battery level again!//
===== Housing Integration =====

//tdb//

===== Usage Example with OpenHAB =====


//tdb//