Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
v0.9.0 RC3 with power switch fix
#1
The RC3 for the upcoming v0.9.0 is out. It contains a bugfix for the power switch:
  • Fix writing timeout value of 0 to e2p when timeout was counted down completely. The power switch was toggling state again after timeout after power loss even if this was not intended.

So if you're using a power switch, it would be nice of you if you could test especially the behavior after power loss (disconnect device from power supply to test). Thanks!

Download is available on the builds download page.


Forum Jump:


Users browsing this thread: 1 Guest(s)